How can i send an email to contacts using the blind copy?

There are several ways to do this the easiest is: Depending on version


When you are ready to send the email - select the TO: on the address line - It will bring you to your address book - Select the persons you want to send to and put a check in the BCC box. I am not sure if you need a person (also) in the TO: field but I sent the note back to myself. As a courtesy - I advise the person that they are being bcc'ed if that is all on the list.

How can i send an email to contacts using the blind copy?
Send the email to your address (your email address), and put all the contacts in blind carbon copy or If you don't mind if the contacts see each others email addresses then create a group within your Email provider and send the email to the entire group.





Sending messages through carbon copy will enable the mail to be sent to the contacts without each person knowing if the email was sent to any other person.





Hope this helps
Reply:Just use the bcc. on the 'compose' page. Also, if you want to send the e-mail to a lot of people, hold the control key down and hit the 'Insert Address' at the same time and you'll get a list of all your addresses. Then just go down the line and click bcc under the names you are sending to.
Reply:If you're using Yahoo! Mail Beta...


click "compose"


at the end of the "To:" line click on "Show BCC"


a new line with "BCC:" should appear.


Just type the desired email addresses and send.
Reply:Which client do you use?